Bounded states for breathers–soliton and breathers of sine–Gordon equation

Nonlinear Dynamics - The Wronskian solutions to the sine–Gordon (sG) equation that can provide interaction of different kinds of solutions are revisited. And a novel expression of N-soliton...     

原子系综中光学腔增强的Duan-Lukin-Cirac-Zoller写过程激发实验

原子系综中的Duan-Lukin-Cirac-Zoller(DLCZ)过程是产生光与原子(量子界面)量子关联和纠缠的重要手段.当一束写光与原子发生作用时,将会产生斯托克斯(Stokes)光子的自发拉曼散射,并同时产生一个自旋波(spin-wave)存储在原子系综中,上述过程即为DLCZ量子记忆产生过程.这一过程被广泛地研究.本文将87Rb原子系综放入驻波腔,并使Stokes光子与光学腔共振,我们观察到有腔且锁定的情况下Stokes光子产生概率比无腔时增大了8.7倍.在此条件下研究了Stokes光子产生概率和写光功率的关系,Stokes光子产生概率随写光功率线性增大.     

Rate sensitivity and deformation mechanism of semi-crystalline polymers during instrumented indentation

Instrumented indentation tests using both constant loading rate (CLR) and continuous stiffness measurement (CSM) operation modes were performed to investigate the deformation mechanism and their sensitivity to the deformation rate in semi-crystalline polymers through the quantitative analysis of load-depth loading and unloading curves. The strain rate was constant during the CSM tests, while the strain rate decreased with the increasing of loading time in CLR tests. The mechanical response mechanism of the semi-crystalline polymers to these tests was very complicated because of the combined effects of strain-hardening in the crystal phase and strain-softening in the amorphous phase. Results show that the loading index m reflects the strain-hardening or strain-softening response during indentation. When m > 2, the mechanical response was due to the strain-hardening, and when m < 2, the response was due to strain-softening. A method based on the measured contact hardness was proposed to obtain the unloading stiffness, and the other mechanical parameters could then be determined according to the unloading stiffness.     

Semi-invariants of binary forms and Sylvester’s theorem

The Ramanujan Journal - We obtain a combinatorial formula related to the shear transformation for semi-invariants of binary forms, which implies the classical characterization of semi-invariants in...     

Effects of longitudinal fire source locations on the maximum temperature and longitudinal temperature decay in a mountain tunnel with vertical shaft: an experimental investigation and empirical model

Journal of Thermal Analysis and Calorimetry - Few investigations have focused on the influence of longitudinal fire source location on the temperature profile of smoke induced by fire in a tunnel...     

Electrodeposited molybdenum-doped Co3O4 nanosheet arrays for high-performance and stable hybrid supercapacitors

Journal of Solid State Electrochemistry - Long-cycle stability and high-energy density are big challenges for developing high-performance hybrid supercapacitor (HSC) electrode materials. In this...     

Qualitative and quantitative determination of Atractylodes rhizome using ultra‐performance liquid chromatography coupled with linear ion trap–Orbitrap mass spectrometry with data‐dependent processing

A quick and effective workflow based on ultra‐performance liquid chromatography coupled with electron spray ionization and LTQ‐Orbitrap mass spectrometry (UPLC‐LTQ‐Orbitrap MS) was established for compositional analysis and screening of the characteristic compounds of three species of Atractylodes rhizome for quality evaluation. This technique was employed to determine the seven main components in Atractylodes rhizome samples. Ultimately, 78 constituents were identified; of these, seven characteristic compounds were selected for species discrimination, comprising atractylodin (63), atractylenolide I (43), atractylenolide II (49), atractylenolide III (53), atractylon (69), methyl‐atractylenolide II (54) and (4E,6E,12E)‐tetradecadecatriene‐8,10‐diyne‐1,3‐diacetate (59). The seven main compounds, including six characteristic compounds, were simultaneously determined in 29 batches of Atractylodes rhizome samples. Thus, the method validation showed acceptable results. Quantitative analysis showed significantly different contents of the seven main components among the three species of Atractylodes rhizome, which indicates possible distinctions in the pharmacological effects. This established method can simultaneously provide qualitative and quantitative results for compositional characterization of Atractylodes rhizomes and for quality control.     

Synthesis,cytotoxicity, apoptosis and cell cycle arrest of a monoruthenium(II)-substituted Dawson polyoxotungstate

By 5-h reaction of cis-[Ru^IICl₂(DMSO)₄] (M2) with K₁₀[α₂-P₂W₁₇O₆₁] (M3) in ice-cooled, HCl-acidic aqueous solution, a water-soluble 1:2-type diamagnetic ruthenium(II) complex of formula K₁₈[Ru^II(DMSO)₂(P₂W₁₇O₆₁)₂]·35H₂O (M1) was unexpectedly obtained as an analytically pure, homogeneous tan-colored solid, in which two DMSO ligands are coordinated to the ruthenium(II) atom. The cytotoxic potential of the complex was tested on C33A, DLD-1, and HepG-2 cancer cells and human normal embryonic lung fibroblasts cell MRC-5; the viability of the treated cells was evaluated by MTT assay. The mode of cell death was assessed by morphological study of DNA damage and apoptosis assays. Compound M1 induced cell death in a dose-dependent manner, and the mode of cell death was essentially apoptosis though necrosis was also noticed. Cell cycle analysis by flow cytometry indicated that M1 caused cell cycle arrest and accumulated cells in S phase.     

The h-SbxWO3+2x Oxygen Excess Antimony Tungsten Bronze

We describe the previously unreported oxygen excess hexagonal antimony tungsten bronze with composition Sb_0.5W₃O₁₀, in the following denoted as h-Sb_xWO_3+2x with x=0.167, to demonstrate its analogy to classical A_xWO₃ tungsten bronzes. This compound forms in a relatively narrow temperature range between 580 °C<T<620 °C. It was obtained as a dark-blue polycrystalline powder, and as thin, needle-shaped, blue single crystals. h-Sb_xWO_3+2x crystallizes in the hexagonal space group P6/mmm with the cell parameters a=7.4369(4) Å and c=3.7800(2) Å. The antimony and excess oxygen occupy the hexagonal channels within the network of corner-sharing WO₆ octahedra. h-Sb_xWO_3+2x has a resistivity of ρ_{300 K}≈1.28 mΩ cm at room temperature, with little if any temperature-dependence on cooling. DFT calculations on a simplified model for this compound find a metallic-like electronic structure with the Fermi level falling within rather flat bands, especially around the Γ point.